This circuit sends the park/neutral position switch assembly signals to the clearance warning ECU assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G23 clearance warning ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G23-1 (PL) - Body ground | Engine switch on (IG)
Shift lever in P |
11 to 14 V |
| G23-1 (PL) - Body ground | Engine switch on (IG)
Shift lever in any position other than P |
Below 1 V |
| G23-13 (RL) - Body ground | Engine switch on (IG)
Shift lever in R |
11 to 14 V |
| G23-13 (RL) - Body ground | Engine switch on (IG)
Shift lever in any position other than R |
Below 1 V |
OK
NG
Disconnect the G23 clearance warning ECU assembly connector.
Disconnect the D4 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G23-1 (PL) - D4-6 (PL) | Always | Below 1 Ω |
| G23-1 (PL) - Body ground | Always | 10 kΩ or higher |
| G23-13 (RL) - D4-1 (RL) | Always | Below 1 Ω |
| G23-13 (RL) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G23-1 (PL) - D4-3 (PL) | Always | Below 1 Ω |
| G23-1 (PL) - Body ground | Always | 10 kΩ or higher |
| G23-13 (RL) - D4-2 (RL) | Always | Below 1 Ω |
| G23-13 (RL) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the D4 park/neutral position switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D4-2 (RB) - Body ground | Engine switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D4-1 (RB) - Body ground | Engine switch on (IG) | 11 to 14 V |
Proceed to the next step based on the check result.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for U241E) | B |
| OK (for U660E) | C |
| OK (for K112) | D |
A
B
(See pageDrivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>PARK / NEUTRAL POSITION SWITCH>REMOVAL)
C
(See pageDrivetrain>U660E (AUTOMATIC TRANSMISSION / TRANSAXLE)>PARK / NEUTRAL POSITION SWITCH>REMOVAL)
D