The rear corner ultrasonic sensor (RH) is installed on the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasonic sensor (RH) . If the rear corner ultrasonic sensor (RH) has an open circuit or other malfunction, it will not function normally.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AE9 | A malfunction of the rear corner ultrasonic sensor (RH) | ·
Rear corner ultrasonic sensor (RH) ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the engine switch on (IG) and turn the clearance sonar main switch (combination switch assembly) on. Then clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| Only DTC C1AE9 is output | A |
| DTC C1AE9 and C1AED are output | B |
| No DTCs are output | C |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Replace the rear corner ultrasonic sensor (RH) with a known good one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>REMOVAL).
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AE9 is output | A |
| No DTCs are output | B |
A
B