Home › Engine / Hybrid System › 2AZ-FE STARTING › PUSH-BUTTON START › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059575 2AZ-FE STARTING _0292081 PUSH-BUTTON START Y

2AZ-FE STARTING  PUSH-BUTTON START  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the push-button start function.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Using the GTS, check if the CAN communication system is functioning normally (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

4.CHECK FOR DTC*

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

4.CHECK FOR DTC*
a.

Check for DTCs and note any stored DTCs (See page Engine / Hybrid System>2AZ-FE STARTING>PUSH-BUTTON START>DTC CHECK / CLEAR).


b.

Delete the DTCs.


c.

Check whether the same DTC(s), relevant to the SFI or push-button starts, recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.

Result:
Result Proceed to
DTC output does not reoccur A
SFI system DTC output reoccurs B
Push-button start DTC output reoccurs C




A

5.PROBLEM SYMPTOMS TABLE

B

GO TO SFI SYSTEM

C

7.ADJUST, REPAIR OR REPLACE
5.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END