Use these procedures to troubleshoot the air conditioning system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
A
B
Check DTCs or sensor check codes.
Write down the DTCs or sensor check codes.
Clear the DTCs or sensor check codes.
Check whether the DTCs or sensor check codes recur.
Reproduce the problem symptoms in accordance with the DTCs or sensor check codes that were written down, and check whether the DTCs or sensor check codes recur.
Refer to the DTC chart when any DTCs or sensor check codes are output.
| Result | Proceed to |
|---|---|
| DTC or sensor check code is not output | A |
| DTC or sensor check code is output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
A
B
DATA LIST / ACTIVE TEST (See page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM>DATA LIST / ACTIVE TEST)
Panel diagnosis (indicator check) (See page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM>CHECK MODE PROCEDURE)
Panel diagnosis (sensor check) (See page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM>CHECK MODE PROCEDURE)
Panel diagnosis (actuator check) (See page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM>CHECK MODE PROCEDURE)
Terminals of ECU (See page Vehicle Interior>AIR CONDITIONING>AIR CONDITIONING SYSTEM>TERMINALS OF ECU)
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT