Home › Vehicle Interior › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292018 BACK DOOR CLOSER SYSTEM Y

ENGINE HOOD / DOOR  BACK DOOR CLOSER SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

The back door closer system troubleshooting procedures are based on the premise that the power back door system is operating normally. Check the power back door system first before troubleshooting the back door closer system (See page Vehicle Interior>ENGINE HOOD / DOOR>POWER BACK DOOR SYSTEM>PROBLEM SYMPTOMS TABLE).

·

Use these procedures to troubleshoot the back door closer system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
a.

Use the intelligent tester to check if the CAN communication system is functioning normally.

Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output B




A

4.CHECK FOR DTC*

B

GO TO CAN COMMUNICATION SYSTEM

4.CHECK FOR DTC*


c.

Recheck for DTCs (See page Vehicle Interior>ENGINE HOOD / DOOR>BACK DOOR CLOSER SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC is not output A
DTC is output B




A

5.PROBLEM SYMPTOMS TABLE

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

5.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed on problem symptoms table A
Fault is listed on problem symptoms table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.REPAIR OR REPLACE
7.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END