Use these procedures to troubleshoot the sliding roof system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the intelligent tester, check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B
Check for DTCs (See page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR).
Clear the DTCs (See page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR).
Recheck the DTCs (See page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Operation Check (See page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>OPERATION CHECK).
Terminals of ECU (See page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>TERMINALS OF ECU).
Data List / Active Test (See page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>DATA LIST / ACTIVE TEST).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT