Use the following procedure to troubleshoot the tire pressure warning system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer to confirm the problem.
It is important to collect as much specific information as possible from the customer to allow for a quick repair.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Set the tire pressure to the specified value (See page Drivetrain>TIRE AND WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).
Make sure the tires are cool when adjusting the tire pressure.
Display "ID Tire Inflation Pressure" in the Data List and check that the tire pressure values match the adjusted pressure amount.
It may take a few minutes until the values are displayed.
Perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION).
| Condition | Proceed to |
|---|---|
| Tire pressure warning light remains on | A |
| Tire pressure warning light goes off | B |
The warning threshold value changes depending on the driving conditions during initialization. As a result, the tire pressure warning light may not turn off even if the tire pressure is adjusted to the specified pressure.
A
B
Check for DTCs (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
Refer to Diagnostic Trouble Code Chart (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Problem Symptoms Table (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>PROBLEM SYMPTOMS TABLE).
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Electronic Circuit Inspection Procedure (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>PROBLEM SYMPTOMS TABLE).
| Proceed to |
|---|
| NEXT |
NEXT
Repair or replace parts based on the diagnosis result.
| Proceed to |
|---|
| NEXT |
NEXT
Check the Data List to confirm that the tire inflation pressure has been received (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST).
Perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION).
Confirm that the initialization has been completed.
| Proceed to |
|---|
| NEXT |
NEXT