HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014
- HINT:
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.
- *: Use the intelligent tester.
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
- Refer to the Customer Problem Analysis (Click here).
| |||||
| 3.CONNECT INTELLIGENT TESTER TO DLC3* |
| |||||
| 4.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
- Refer to the DTC Check / Clear (Click here).
| |||||
| 5.VISUAL INSPECTION |
| |||||
| 6.SETTING CHECK MODE DIAGNOSIS* |
- Refer to the Check Mode Procedure (Click here).
| |||||
| 7.PROBLEM SYMPTOM CONFIRMATION |
-
Refer to the Road Test (Click here).
| Result |
Proceed to |
| Symptom does not occur |
A |
| Symptom occurs |
B |
|
|||||
| |||||
| 8.SYMPTOM SIMULATION |
- Refer to the Electronic Circuit Inspection Procedure (Click here).
| |||||
| 9.DTC CHECK |
-
Refer to the DTC Check / Clear (Click here).
| Result |
Proceed to |
| DTC is not output |
A |
| DTC is output |
B |
|
|||||
| |||||
| 10.BASIC INSPECTION |
-
Refer to the Automatic Transmission Fluid (Click here).Refer to the Park/Neutral Position Switch (Click here).Refer to the Floor Shift Assembly (Click here).
|
|||||
| |||||
| 11.MECHANICAL SYSTEM TEST |
- Refer to the Mechanical System Test (Click here).
|
|||||
| |||||
| 12.HYDRAULIC TEST |
- Refer to the Hydraulic Test (Click here).
|
|||||
| |||||
| 13.MANUAL SHIFTING TEST |
- Refer to the Manual Shifting Test (Click here).
|
|||||
| |||||
| 14.PROBLEM SYMPTOMS TABLE CHAPTER 1 |
- Refer to the Problem Symptoms Table (Click here).
|
|||||
| |||||
| 15.PROBLEM SYMPTOMS TABLE CHAPTER 2 |
- Refer to the Problem Symptoms Table (Click here).
| |||||
| 16.PART INSPECTION |
|
| 17.DTC CHART* |
- Refer to the Diagnostic Trouble Code Chart (Click here).
| |||||
| 18.CIRCUIT INSPECTION* |
| |||||
| 19.REPAIR OR REPLACE |
| |||||
| 20.CONFIRMATION TEST* |
| |||||