HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jul 2007 – Nov 2007
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014
- HINT:
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.
- *: Use the intelligent tester.
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CONNECT INTELLIGENT TESTER TO DLC3 * |
| |||||
| 4.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA * |
- Refer to the DTC CHECK / CLEAR (Click here).
| |||||
| 5.VISUAL INSPECTION |
| |||||
| 6.SETTING CHECK MODE DIAGNOSIS * |
- Refer to the CHECK MODE PROCEDURE (Click here).
| |||||
| 7.PROBLEM SYMPTOM CONFIRMATION |
-
Refer to the ROAD TEST (Click here).
- Result:
Result
Proceed to
Symptom does not occur
A
Symptom occurs
B
|
|||||
| |||||
| 8.SYMPTOM SIMULATION |
- Refer to the ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).
| |||||
| 9.DTC CHECK * |
-
Refer to the DTC CHECK / CLEAR (Click here).
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 10.BASIC INSPECTION |
-
Refer to the AUTOMATIC TRANSMISSION FLUID (Click here).Refer to the PARK/NEUTRAL POSITION SWITCH (Click here).Refer to the FLOOR SHIFT ASSEMBLY (Click here).
|
|||||
| |||||
| 11.MECHANICAL SYSTEM TEST |
- Refer to the MECHANICAL SYSTEM TEST (Click here).
|
|||||
| |||||
| 12.HYDRAULIC TEST |
- Refer to the HYDRAULIC TEST (Click here).
|
|||||
| |||||
| 13.MANUAL SHIFTING TEST |
- Refer to the MANUAL SHIFTING TEST (Click here).
|
|||||
| |||||
| 14.PROBLEM SYMPTOMS TABLE CHAPTER 1 |
- Refer to the PROBLEM SYMPTOMS TABLE (Click here).
|
|||||
| |||||
| 15.PROBLEM SYMPTOMS TABLE CHAPTER 2 |
- Refer to the PROBLEM SYMPTOMS TABLE (Click here).
| |||||
| 16.PART INSPECTION |
|
| 17.DTC CHART* |
- Refer to the DIAGNOSTIC TROUBLE CODE CHART (Click here).
| |||||
| 18.CIRCUIT INSPECTION* |
| |||||
| 19.REPAIR OR REPLACE |
| |||||
| 20.CONFIRMATION TEST* |
| |||||