2011-2016 FJ Cruiser · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014

HINT:
  1. The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure that there is no trouble in the CAN communication system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      Refer to the Customer Problem Analysis (Click here).
    NEXT

    3.CONNECT INTELLIGENT TESTER TO DLC3*
      NEXT

      4.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
        Refer to the DTC Check / Clear (Click here).
      NEXT

      5.VISUAL INSPECTION
        NEXT

        6.SETTING CHECK MODE DIAGNOSIS*
          Refer to the Check Mode Procedure (Click here).
        NEXT

        7.PROBLEM SYMPTOM CONFIRMATION
          Refer to the Road Test (Click here).
          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B

        B.
        A

        8.SYMPTOM SIMULATION
          Refer to the Electronic Circuit Inspection Procedure (Click here).
        NEXT

        9.DTC CHECK
          Refer to the DTC Check / Clear (Click here).
          Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B

        B.
        A

        10.BASIC INSPECTION
          Refer to the Automatic Transmission Fluid (Click here).Refer to the Park/Neutral Position Switch (Click here).Refer to the Floor Shift Assembly (Click here).

        NG.
        OK

        11.MECHANICAL SYSTEM TEST
          Refer to the Mechanical System Test (Click here).

        NG.
        OK

        12.HYDRAULIC TEST
          Refer to the Hydraulic Test (Click here).

        NG.
        OK

        13.MANUAL SHIFTING TEST
          Refer to the Manual Shifting Test (Click here).

        NG.
        OK

        14.PROBLEM SYMPTOMS TABLE CHAPTER 1
          Refer to the Problem Symptoms Table (Click here).

        NG.
        OK

        15.PROBLEM SYMPTOMS TABLE CHAPTER 2
          Refer to the Problem Symptoms Table (Click here).
        NEXT

        16.PART INSPECTION

          NEXT.
          17.DTC CHART*
            Refer to the Diagnostic Trouble Code Chart (Click here).
          NEXT

          18.CIRCUIT INSPECTION*
            NEXT

            19.REPAIR OR REPLACE
              NEXT

              20.CONFIRMATION TEST*
                NEXT

                ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2012 – Jul 2014)ROAD TEST (Jul 2007 – Jul 2009) →