2011-2016 FJ Cruiser · Service Manual RESTRAINTS

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Aug 2011 – Jul 2012

Versions by build date: Jul 2007 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the SRS warning light.

HINT:
  1. Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communication system (Click here).
  2. When a warning light keeps blinking, a short to ground in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  3. The DTC output mode signal is transmitted through the CAN to an ECU including the center airbag sensor assembly. Thus if no systems enter DTC output mode, the ECM may have a malfunction.


WIRING DIAGRAM

C246170E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
C246213E01
  1. Turn the ignition switch off.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-13 (TC) - E81-28 (TC)
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    DLC3
    *b
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS, ECU OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND)

  1. C196989E13
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    DLC3



NG
REPAIR OR REPLACE HARNESS, ECU OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (TC CIRCUIT OF ECM)

  1. C248055E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E81-28 (TC) - Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS, ECU OR CONNECTOR
OK


4. CHECK DTC
SST
09843-18040  

  1. C196989E16
    Using SST, connect terminals TC and CG of the DLC3.

    NOTICE:
    Connect the terminals to the correct positions to avoid a malfunction.

    Text in Illustration 
    *a
    DLC3
    Result 
    Result
    Proceed to
    DTC output mode is set in each ECU.
    A
    DTC output mode is not set in ECM.
    B
    DTC output mode is not set in center airbag sensor assembly.
    C



B
REPLACE ECM (Click here)

C
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← TC and CG Terminal Circuit (Jul 2007 – Jul 2011)TC and CG Terminal Circuit (from Aug 2012) →