2011-2016 FJ Cruiser · Service Manual BRAKE

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Aug 2008 – Oct 2010

Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Oct 2010 from Nov 2010


CHECK DLC3
  1. Check DLC3 (Click here).


DIAGNOSIS (without VSC OFF Switch)

  1. If the skid control ECU detects a malfunction, the ABS warning light, VSC TRC warning light, BRAKE warning light, VSC OFF indicator light and/or SLIP indicator light come on in accordance with the trouble area to warn the driver.
    The table below indicates which lights come on when there is a malfunction in a particular function.
    C168945E02

  2. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the intelligent tester.

  3. This system has a sensor signal check function (Click here). The DTCs can be read by connecting SST (09843-18040) between terminals TS and CG of the DLC3 and observing the blinking of the ABS warning light and VSC TRC warning light, or by connecting the intelligent tester.


DIAGNOSIS (with VSC OFF Switch)

  1. C193216E01
    If the skid control ECU detects a malfunction, the ABS warning light, BRAKE warning light and/or SLIP indicator light come on in accordance with the trouble area to warn the driver.
    The table below indicates which lights come on when there is a malfunction in a particular function.

  2. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the intelligent tester.

  3. This system has a sensor signal check function (Click here). The DTCs can be read by connecting SST (09843-18040) between terminals TS and CG of the DLC3 and observing the blinking of the ABS warning light and SLIP indicator light, or by connecting the intelligent tester.


WARNING LIGHT AND INDICATOR LIGHT CHECK
C193217E01
  1. Release the parking brake.

    NOTICE:
    When releasing the parking brake, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

  2. w/o VSC OFF Switch:
    Check that the ABS warning light, VSC TRC warning light, BRAKE warning light, VSC OFF indicator light and SLIP indicator light come on when the ignition switch is turned to ON, and go off in about 3 seconds.
    w/ VSC OFF Switch:
    Check that the ABS warning light, BRAKE warning light, VSC OFF indicator light and SLIP indicator light come on when the ignition switch is turned to ON, and go off in about 3 seconds.

    HINT:
    If the lights do not illuminate, confirm whether the bulbs have burned out, and also check the wire harness between the skid control ECU and the combination meter.
    If the light remains on, troubleshoot the effected light circuit by proceeding to the page indicated below.
    Trouble Area
    See Page
    ABS warning light circuit
    Click here
    VSC TRC warning light circuit (*1)
    Click here
    BRAKE warning light circuit
    Click here
    VSC OFF indicator light circuit
    Click here
    SLIP indicator light circuit
    Click here
    *1: w/o VSC OFF Switch

← DIAGNOSIS SYSTEM (Jul 2007 – Jul 2008)DIAGNOSIS SYSTEM (from Nov 2010) →