ABS Warning Light does not Come ON
Circuit diagnosis · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011
DESCRIPTION
Refer to ABS Warning Light Remains ON (Click here).WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. CHECK DTC |
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| OK | |
| 2. CHECK CAN COMMUNICATION LINE |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).
- OK:
- CAN Bus Check indicates no malfunctions in CAN communication.
|
|
||||
| OK | |
| 3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (INDICATE. LAMP ABS) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the tester, perform the Active Test.
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. Lamp ABS
ABS warning light
OFF/ON
Perform the test with the vehicle stopped and the engine idling.
- OK:
- The ABS warning light turns ON or OFF according to the tester operations.
|
|
||||
| OK | ||
| ||
| 4. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the tester, perform the Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Light
ABS warning light
Warning light ON/OFF
Observe the combination meter.
Using the tester, check that the Data List display changes from OFF to ON.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ABS Warning Light
ABS warning light/ ON or OFF
ON: warning on
OFF: warning off
-
- OK:
- Data List display changes from OFF to ON
|
|
||||
| OK | ||
| ||
