2011-2016 FJ Cruiser · Service Manual BRAKE

Skid Control Buzzer Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The skid control buzzer sounds intermittently when the temperature of the actuator increases excessively during TRC or A-TRAC system operation.
This buzzer sounds continuously when a low pressure malfunction occurs in the accumulator.

WIRING DIAGRAM

C164950E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the following menu items: Chassis / ABS/VSC/TRC/ Active TestSelect the "VSC H/B Warning Buzzer" in the Active Test and operate the skid control buzzer on the intelligent tester.

    ACTIVE TEST: ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic note
    VSC H/B Warning Buzzer
    Skid control buzzer
    Skid control buzzer ON or OFF
    Buzzer can be heard

  1. Check that the buzzer sounds/stops when the skid control buzzer is turned on/off by using the intelligent tester.

    Result:
    Result
    Proceed to
    Buzzer does not sound or sounds constantly
    A
    Buzzer sounds/stops
    B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A


2. INSPECT SKID CONTROL BUZZER (POWER SOURCE CIRCUIT)

  1. I044040E03
    Disconnect the skid control buzzer connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Specified Condition
    A6-2 (IG1) - Body ground
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


3. INSPECT SKID CONTROL BUZZER ASSEMBLY

  1. F002192E08
    Disconnect the skid control buzzer connector.

  1. Apply battery voltage to terminals 1 and 2 of the skid control buzzer connector, and check that the buzzer sounds.

    OK:
    The skid control buzzer sound should be heard.



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY
OK


4. CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU)

  1. C124803E02
    Disconnect the skid control ECU connector.

  1. Disconnect the skid control buzzer connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-30 (BZ) - A6-1 (BZ)
    Below 1 Ω
    A4-30 (BZ) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← A-TRAC Indicator Light does not Come ON (from Nov 2012)VSC Buzzer Circuit (Nov 2010 – Jul 2011) →