2011-2016 FJ Cruiser · Service Manual BRAKE

VSC Buzzer Circuit

Circuit diagnosis · Vehicles built Nov 2010 – Jul 2011

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.
The combination meter has a built-in skid control buzzer.
Sounds intermittently to inform driver if temperature of hydraulic brake booster has increased excessively due to continuous operation of TRC and A-TRAC.
Sounds continuously to alert driver that hydraulic pressure of accumulator in hydraulic brake booster has decreased.

WIRING DIAGRAM

C231258E02

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform the zero point calibration (Click here).


1. CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON/OFF
    Buzzer can be heard

  1. Check that the buzzer sounds or stops in accordance with the tester.

    Result 
    Result
    Proceed to
    Buzzer does not sound or stop
    A
    Buzzer sounds and stops
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3. REPLACE COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Replace the combination meter (Click here).


NEXT


4. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SKID CONTROL BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON/OFF
    Buzzer can be heard

  1. Check that the buzzer sounds or stops in accordance with the tester.

    Result 
    Result
    Proceed to
    Buzzer does not sound or stop
    A
    Buzzer sounds and stops
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← Skid Control Buzzer Circuit (Jul 2007 – Oct 2010)VSC Buzzer Circuit (Aug 2011 – Jul 2012) →