When replacing the master cylinder solenoid, perform zero point calibration (Click here).
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the "Brake Warning Light" in the Active Test and operate the BRAKE warning light using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC/ Active Test
ACTIVE TEST: ABS/VSC/TRC
Tester Display
Test Part
Control Range
Diagnostic Note
Brake Warning Light
BRAKE warning light
BRAKE warning light ON or OFF
Observe combination meter
Check that the BRAKE warning light turns on and off in the combination meter using the intelligent tester.
OK:
The BRAKE warning light turns ON and OFF in accordance with the intelligent tester operation.