2011-2016 FJ Cruiser · Service Manual BRAKE

Brake Warning Light does not Come ON

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select the "Brake Warning Light" in the Active Test and operate the BRAKE warning light using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC/ Active Test

    ACTIVE TEST: ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Brake Warning Light
    BRAKE warning light
    BRAKE warning light ON or OFF
    Observe combination meter

  1. Check that the BRAKE warning light turns on and off in the combination meter using the intelligent tester.

    OK:
    The BRAKE warning light turns ON and OFF in accordance with the intelligent tester operation.



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135297E01
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A5-3 (BRL) - E13-31 (PKB)
    Below 1 Ω
    A5-3 (BRL) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← Brake Warning Light does not Come ON (Jul 2007 – Jul 2009)Brake Warning Light does not Come ON (Nov 2010 – Jul 2011) →