Slip Indicator Light Remains ON
Circuit diagnosis · Vehicles built Jul 2007 – Jul 2008
Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012
DESCRIPTION
- The SLIP indicator blinks when any of the TRC and VSC operate.
- When the system fails, the SLIP indicator light illuminates to warn the driver.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CHECK DTC |
 |
Check for the DTCs (Click here).
- Result:
Result
|
Proceed to
|
DTC not output
|
A
|
DTC output
|
B
|
|
B |
 |
|
| REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
|
|
|
| A |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
 |
- Disconnect the skid control ECU connector.
Disconnect the combination meter connector.
Measure the resistance.
- Standard resistance:
Tester Connection
|
Specified Condition
|
A4-34 (IND) - E14-7 (SLIP)
|
Below 1 Ω
|
A4-34 (IND) - Body ground
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. INSPECT COMBINATION METER ASSEMBLY |
 |
Check the combination meter system (Click here).
- OK:
- Combination meter is normal.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|