2011-2016 FJ Cruiser · Service Manual BRAKE

Slip Indicator Light Remains ON

Circuit diagnosis · Vehicles built Aug 2008 – Jul 2009

Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

DESCRIPTION

w/o VSC OFF Switch:
The SLIP indicator blinks when any of the TRC and VSC operate.
w/ VSC OFF Switch:
  1. The SLIP indicator blinks when any of the TRC and VSC operate.
  2. When the rear differential is locked the SLIP indicator light illuminates and the VSC system will not operate.
  3. When the VSC system fails, the SLIP indicator light illuminates to warn the driver.

WIRING DIAGRAM

C195510E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK DTC
  1. Check for the DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135294E10
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-34 (IND) - E14-7 (SLIP)
    Always
    Below 1 Ω
    A4-34 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← Slip Indicator Light Remains ON (Jul 2007 – Jul 2008)Slip Indicator Light Remains ON (Aug 2009 – Oct 2010) →