2011-2016 FJ Cruiser · Service Manual BRAKE

VSC TRC Warning Light Remains ON

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010

DESCRIPTION

When the skid control ECU stores DTCs, the VSC and TRC functions are deactivated and the VSC TRC warning light comes on in the combination meter.

WIRING DIAGRAM

C164947E03

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK DTC
  1. Check if DTCs for VSC are recorded (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A


2. INSPECT SKID CONTROL ECU CONNECTOR
  1. Check that the ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135294E01
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-36 (VSCW) - E14-6 (VSCW)
    Below 1 Ω
    A4-36 (VSCW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← Crawl Indicator Light does not Come ON (from Nov 2012)VSC TRC Warning Light Remains ON (Aug 2009 – Oct 2010) →