VSC TRC Warning Light Remains ON
Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010
DESCRIPTION
When the skid control ECU stores DTCs, the VSC and TRC functions are deactivated and the VSC TRC warning light comes on in the combination meter.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CHECK DTC |
 |
Check if DTCs for VSC are recorded (Click here).
- Result:
Result
|
Proceed to
|
DTC not output
|
A
|
DTC output
|
B
|
|
B |
 |
|
| REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
|
| A |
|
 |
|
| 2. INSPECT SKID CONTROL ECU CONNECTOR |
 |
Check that the ECU connector is securely connected.
- OK:
- The connector is securely connected.
|
NG |
 |
|
| CONNECT CONNECTOR CORRECTLY |
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
 |
- Disconnect the skid control ECU connector.
Disconnect the combination meter connector.
Measure the resistance.
- Standard resistance:
Tester Connection
|
Specified Condition
|
A4-36 (VSCW) - E14-6 (VSCW)
|
Below 1 Ω
|
A4-36 (VSCW) - Body ground
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 4. INSPECT COMBINATION METER ASSEMBLY |
 |
Check the combination meter system (Click here).
- OK:
- Combination meter is normal.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|