2011-2016 FJ Cruiser · Service Manual BRAKE

C1248/48 Open Circuit in Rear Differential Lock

Diagnostic trouble codes · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The 4WD control ECU stimulates the actuator to lock the rear differential in accordance with the rear differential lock switch. The skid control ECU monitors the transfer indicator switch (rear differential lock) and if the rear differential is locked, at which time the rear differential lock indicator light is illuminated, prohibits ABS, TRC and VSC controls. At the same time, the skid control ECU illuminates the ABS warning light, VSC OFF indicator light and SLIP indicator light.
DTC No.
DTC Detecting Condition
Trouble Areas
C1248/48
At vehicle speed of 50 km/h (31 mph) or more, 3 seconds or more elapse after rear differential changes from free to lock.
  1. Rear differential lock indicator switch
  2. Rear differential lock indicator switch circuit
  3. Master cylinder solenoid (skid control ECU)

WIRING DIAGRAM

C164941E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. INSPECT SKID CONTROL ECU TERMINAL VOLTAGE (EXI3)

  1. C121700E52
    Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Vehicle Condition
    Rear Differential Lock Indicator Light
    Specified Condition
    A4-26 (EXI3) - Body ground
    Rear Differential free
    OFF
    8 to 14 V
    A4-26 (EXI3) - Body ground
    Rear Differential locked
    ON
    1.5 V



NG
Go to step 3
OK


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Drive the vehicle at 50 km/h (31 mph) or more for 3 seconds or more with the rear differential free.

  1. Check if the same DTC is detected (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)

3. INSPECT REAR DIFFERENTIAL LOCK INDICATOR SWITCH

  1. F052057E05
    Disconnect the rear differential lock indicator switch connector.

  1. Remove the rear differential lock indicator switch.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D2-1 - D2-2
    Pushed
    Below 1 Ω
    D2-1 - D2-2
    Free
    10 kΩ or higher



NG
REPLACE REAR DIFFERENTIAL LOCK INDICATOR SWITCH
OK


4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - REAR DIFFERENTIAL LOCK INDICATOR SWITCH)

  1. C138458E01
    Disconnect the skid control ECU connector.

  1. Disconnect the rear differential lock indicator switch connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-26 (EXI3) - D2-2
    Below 1 Ω
    D2-1 - Body ground
    Below 1 Ω
    D2-2 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1246/46 Master Cylinder Pressure Sensor Malfunction (+ C1281/81) (Jul 2007 – Oct 2010)C1249/49 Open in Stop Light Switch Circuit (Jul 2007 – Oct 2010) →