When replacing the master cylinder solenoid, perform zero point calibration (Click here).
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC TRC WARNING LIGHT)
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the following menu items: Chassis / ABS/VSC/TRC/ Active TestSelect the "VSC Warning Light" in the Active Test and operate the VSC TRC warning light using the intelligent tester.
ACTIVE TEST: ABS/VSC/TRC
Tester Display
Test Part
Control Range
Diagnostic Note
VSC Warning Light
VSC TRC warning light
VSC TRC warning light ON or OFF
Observe combination meter
Check that the VSC TRC warning light turns on and off in the combination meter using the intelligent tester.
OK:
The VSC TRC warning light turns ON and OFF in accordance with the intelligent tester operation.