2011-2016 FJ Cruiser · Service Manual RESTRAINTS

Driver Side Seat Belt Warning Light does not Operate

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

When the ignition switch is ON, the combination meter assembly receives signals from the front seat inner belt assembly (driver side). When the seat belt is unfastened, the combination meter assembly flashes the driver seat belt warning light in the combination meter assembly. When the seat belt is fastened, the combination meter assembly stops flashing the front driver seat belt warning light.

WIRING DIAGRAM

B264127E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DRIVER SIDE SEAT BELT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    ON/OFF
    -

    OK:
    Driver side seat belt warning light condition can be switched by Active Test.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


2. INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE)
  1. Inspect the front seat inner belt assembly (driver side) (Click here).



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) - COMBINATION METER ASSEMBLY AND BODY GROUND)
  1. for LHD

    1. Disconnect the L27 front seat inner belt assembly (driver side) connector.

  1. for RHD

    1. Disconnect the K14 front seat inner belt assembly (driver side) connector.

  1. Disconnect the E13 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    L27-1 (+) - E13-8 (L)
    Always
    Below 1 Ω
    L27-1 (+) - Body ground
    Always
    10 kΩ or higher
    L27-2 (E) - Body ground
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    K14-1 (+) - E13-8 (L)
    Always
    Below 1 Ω
    K14-1 (+) - Body ground
    Always
    10 kΩ or higher
    K14-2 (E) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the combination meter assembly connector.

  1. Reconnect the front seat inner belt assembly (driver side) connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Driver Side Seat Belt Warning Light does not Operate (Jul 2007 – Oct 2010)Front Passenger Side Seat Belt Warning Light Malfunction (Jul 2007 – Oct 2010) →