C1381 Acceleration Sensor Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the deceleration sensor) are stored.
These DTCs are also stored when calibration has not been completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1381 |
At a vehicle speed of more than 3 km/h (2 mph), the deceleration sensor power source malfunction signal is received for 10 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|
||||
| A | |
| 2. INSPECT YAW RATE AND DECELERATION SENSOR (IG, GND TERMINAL) |
Disconnect the yaw rate and deceleration sensor connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E83-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E83-1 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Yaw Rate and Deceleration Sensor)
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Reconnect the yaw rate and deceleration sensor connector.
Clear the DTCs (Click here).
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
| Result |
Proceed to |
| DTC C1381 is not output |
A |
| DTC C1381 is output |
B |
|
|
||||
| A | ||
| ||
