2011-2016 FJ Cruiser · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012


1. INSTALL REAR BUMPER BAR BRACKET LH

  1. B190462
    Install the rear bumper bar bracket with the 2 bolts.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }


2. INSTALL REAR BUMPER BAR BRACKET RH

HINT:
Use the same procedure as for the LH side.


3. INSTALL REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY LH

  1. B135072
    Align the locating pin with the hole and install the rear bumper side support with the 2 bolts.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }


4. INSTALL REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


5. INSTALL REAR BUMPER SIDE STAY LH

  1. B134753
    Insert the hook into the body hole and install the rear bumper side stay with the bolt.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }


6. INSTALL REAR BUMPER SIDE STAY RH

HINT:
Use the same procedure as for the LH side.


7. INSTALL REAR BUMPER ENERGY ABSORBER

  1. B190461
    Install the rear bumper energy absorber.


8. INSTALL REAR BUMPER UPPER RETAINER LH

  1. B134751
    Engage the 3 claws and install the rear bumper upper retainer.

  1. Tighten the 2 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }


9. INSTALL REAR BUMPER UPPER RETAINER RH

HINT:
Use the same procedure as for the LH side.


10. INSTALL REAR BUMPER END RETAINER LH

  1. B134750
    Engage the 2 claws and install the rear bumper end retainer.

  1. Tighten the screw.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }


11. INSTALL REAR BUMPER END RETAINER RH

HINT:
Use the same procedure as for the LH side.


12. INSTALL REAR BUMPER COVER

  1. B190460
    Engage the 6 claws and the 2 clips and install the rear bumper cover.

  1. B198721
    Engage the harness clamp, and connect the connector.

  1. B135141
    Tighten the 7 bolts and the 2 screws.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf } for bolt
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf } for screw

  1. B198720
    Install the clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B190458
    Remove the protective tape.

← REASSEMBLY (from Aug 2012)INSTALLATION (Nov 2010 – Jul 2012) →