C146E Open in ABS Solenoid Relay Circuit
Diagnostic trouble codes · Vehicles built from Aug 2012
Also covers:
- C146F Short in ABS Solenoid Relay Circuit
Versions by build date: Nov 2010 – Jul 2012 from Aug 2012
DESCRIPTION
The solenoid relay supplies power to the ABS solenoid and TRC solenoid.After the ignition switch is turned to ON, the vehicle speed has reached 6 km/h (4 mph) and the solenoid is determined to be normal by the initial check self- diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
These DTCs may be set if the voltage supply to the solenoid relay (+BS) falls below the DTC detection threshold due to the battery or generator outputs being insufficient.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C146E |
When either of following conditions detected:
|
|
| C146F |
Following condition continues for at least 0.2 seconds.
|
Master cylinder solenoid (skid control ECU) |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. INSPECT SKID CONTROL ECU (+BS TERMINAL) |
Disconnect the skid control ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
A4-31 (+BS) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 2. INSPECT SKID CONTROL ECU (GND TERMINAL) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
A4-1 (GND1) - Body ground
Always
Below 1 Ω
A4-32 (GND2) - Body ground
Always
Below 1 Ω
A5-4 (GND3) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
- HINT:
- These codes are stored when a problem is detected in the master cylinder solenoid.
- The solenoid relay is in the master cylinder solenoid.
- Therefore, solenoid relay circuit inspections and relay unit inspections cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.
Clear the DTCs (Click here).
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| OK | ||
| ||
