2011-2016 FJ Cruiser · Service Manual BRAKE

C1417 High Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.
This DTC is cleared when the IG1 terminal voltage returns to normal.
DTC Code
DTC Detection Condition
Trouble Area
C1417
The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.
  1. Charging system
  2. Power source circuit
  3. Internal power supply circuit of the skid control ECU

WIRING DIAGRAM

Refer to DTC C1241 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. INSPECT SKID CONTROL ECU (IG1 TERMINAL)
  1. Disconnect the skid control ECU connector.

  1. C214161E54
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A4-46 (IG1) - Body ground
    Idling
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1417 High Power Supply Voltage Malfunction (Nov 2010 – Jul 2012)C1419 Acceleration Sensor Internal Circuit (+ C1435) (Nov 2010 – Jul 2011) →