2011-2016 FJ Cruiser · Service Manual SECURITIES

REMOVAL

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side (Click here).


2. REMOVE FRONT FLOOR FOOTREST (for LHD)

  1. B130586
    Disengage the 4 claws and remove the front floor footrest.


3. REMOVE FOOTREST CLIP (for LHD)

  1. B130587
    Remove the 2 footrest clips.


4. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side (Click here).


5. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side.


6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

  1. B133853
    Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.


7. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

  1. B133859
    Disengage the 3 claws and separate the hood lock control lever.


8. SEPARATE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)

  1. B267057
    Disengage the 3 claws and separate the fuel lid lock open lever.


9. REMOVE INSTRUMENT PANEL FINISH PLATE

  1. E149562E03
    Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Instrument Panel Finish Plate


10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for LHD)

  1. B133860
    Remove the 2 <E> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.


11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (for RHD)

  1. B267058
    Remove the 2 <E> bolts.

  1. Disengage the 8 clips and 4 guides.

  1. Disconnect the connectors and remove the lower instrument panel finish panel.


12. REMOVE TRANSPONDER KEY AMPLIFIER

  1. E146362E02
    Disconnect the connector.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the transponder key amplifier.

← REMOVAL (Nov 2010 – Jul 2012)INSTALLATION (Jul 2007 – Oct 2010) →