2011-2016 FJ Cruiser · Service Manual BRAKE

C1442/44 Invalid Data Received from Deceleration Sensor

Diagnostic trouble codes · Vehicles built Aug 2008 – Oct 2010

Also covers:

DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition.
DTC Code
DTC Detection Condition
Trouble Area
C1442/44
An invalid data signal is transmitted continuously from the deceleration sensor for 10 seconds or more
Yaw rate and deceleration sensor
C1443/34
An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more
Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTC C1440/98(Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and deceleration sensor, perform zero point calibration (Click here).


1. CHECK DTC
  1. Turn the ignition switch off.

  1. Clear the DTC (Click here).

  1. Start and idle the engine for 60 seconds, and then stop the engine.

  1. Check if the same DTC is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE YAW RATE AND DECELERATION SENSOR (Click here)


← C1442 Invalid Data Received from Acceleration Sensor (+ C1443) (from Aug 2012)C1452 Accumulator Low Pressure (Nov 2010 – Jul 2012) →