2011-2016 FJ Cruiser · Service Manual BRAKE

C1452 Accumulator Low Pressure

Diagnostic trouble codes · Vehicles built from Aug 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
C1452
After braking, the fluid pressure inside the accumulator is below the threshold within 3.2 seconds.
  1. Hydraulic circuit
  2. Master cylinder solenoid (Accumulator pressure sensor)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. CUSTOMER PROBLEM ANALYSIS
  1. Check with the customer to determine if frequent braking has been performed.


NEXT


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Wait for 99 seconds.

  1. Check if the same DTC is output (Click here).

    Result  
    Result
    Proceed to
    DTC is output
    A
    Frequent braking was not performed and DTC is not output
    B
    Frequent braking was performed and DTC is not output
    C

    HINT:
    Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.



B
USE SIMULATION METHOD TO CHECK (Click here)

C
END
A


3. CHECK HYDRAULIC CIRCUIT
  1. Check the hydraulic circuit (Click here).

    OK:
    Hydraulic circuit is normal (no leakage).



NG
REPAIR HYDRAULIC CIRCUIT
OK


4. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor
    Accumulator pressure sensor reading / min.: 0 V, max.: 5 V
    3.58 to 5 V
    If value constant regardless of pump operation, accumulator pressure sensor malfunction suspected.

  1. Check that the accumulator's output value is in the Normal Condition range.

    OK:
    Accumulator pressure sensor value is in the Normal Condition.



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK


5. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1452 Accumulator Low Pressure (Nov 2010 – Jul 2012)C1453 Reservoir Level Switch Disconnected (+ C1454) (Nov 2010 – Jul 2012) →