C1437 Lost Communication with ECM
Diagnostic trouble codes · Vehicles built from Dec 2017
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the ECM via the CAN communication system.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1437 |
When voltage at terminal +BS is 10 to 17.4 V and vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to ECM continuously for 2 seconds or more. |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION) |
Using the GTS, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
EFI Communication Open
ECM communication open detection / Error or Normal
Normal
Error: Momentary interruption
EFI Communication Invalid
ECM communication invalid detection / Error or Normal
Normal
Error: Invalid
- OK:
- Normal (There are no momentary interruptions.)
- HINT:
- Perform the above inspection before removing the sensor and connector.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.
Check that no CAN communication system DTC is output (Click here).
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC C1437 is not output
A
DTC C1437 is output
B
CAN communication system DTC is output
C
|
|
||||
|
|
||||
| A | ||
| ||
