2014-2019 Hiace · Service Manual BRAKE

C1437 Lost Communication with ECM

Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the ECM via the CAN communication system.
DTC No.
DTC Detection Condition
Trouble Area
C1437
When voltage at terminal +BS is 10 to 17.4 V and vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to ECM continuously for 2 seconds or more.
  1. CAN communication system (Skid control ECU to ECM)
  2. Skid control ECU (Brake actuator assembly)
  3. ECM

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).


1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
  1. Using the GTS, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    EFI Communication Open
    ECM communication open detection / Error or Normal
    Normal
    Error: Momentary interruption
    EFI Communication Invalid
    ECM communication invalid detection / Error or Normal
    Normal
    Error: Invalid

    OK:
    Normal (There are no momentary interruptions.)

    HINT:
    Perform the above inspection before removing the sensor and connector.



NG
CHECK CAN COMMUNICATION SYSTEM (Click here)
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine.

  1. Drive the vehicle at a speed of 15 km/h (9 mph) or more for 10 seconds or more.

  1. Check that no CAN communication system DTC is output (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC C1437 is not output
    A
    DTC C1437 is output
    B
    CAN communication system DTC is output
    C



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

C
CHECK CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1437 Lost Communication with ECM (Jan 2015 – Mar 2016)C1437 Lost Communication with ECM (Jan 2017 – Nov 2017) →