PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Result of "How to proceed with Troubleshooting" is "Open in CAN Main Bus Line" |
Open in CAN Main Bus Line |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines" |
Short in CAN Bus Lines |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line" |
Short to B+ in CAN Bus Line |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line" |
Short to GND in CAN Bus Line |
Click here
|
| Result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line" |
Open in One Side of CAN Branch Line |
Click here
|
- HINT:
- Refer to How to Proceed with Troubleshooting for the CAN V1 Bus Check procedure.
| Symptom |
Suspected Area |
See page |
| "Air Conditioning Amplifier" is not displayed on the intelligent tester (w/ Air Conditioning System, except 5L-E) |
Air Conditioning Amplifier Communication Stop Mode |
Click here
|
| "ECM (Engine)" is not displayed on the intelligent tester |
ECM Communication Stop Mode |
Click here
|
| "Combination Meter" is not displayed on the intelligent tester |
Combination Meter ECU Communication Stop Mode |
Click here
|
| "Certification (Smart)" is not displayed on the intelligent tester (w/ Smart Entry and Start System) |
Certification ECU Communication Stop Mode |
Click here
|
| "Headlight swivel (AFS)" is not displayed on the intelligent tester (for LED Headlight) |
AFS Communication Stop Mode |
Click here
|