GENERAL MAINTENANCE
Removal / installation · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
| 1. INSPECT POWER STEERING FLUID |
Inspect the power steering fluid (Click here).
| 2. INSPECT STEERING LINKAGE |
Check the steering linkage for looseness or damage.
Check that:- Tie rod ends do not have excessive play.
- Dust seals and boots are not damaged.
- Boot clamps are not loose.
- Tie rod ends do not have excessive play.
| 3. INSPECT BALL JOINT AND DUST COVER |
Inspect the ball joints for excessive looseness.
Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
Lower the jack until there becomes about half a load on the front coil spring. Place stands under the vehicle for safety.
Check that the front wheels are pointing straight ahead, and block them with chocks.
Using a lever, pry up the end of the lower arm, and check the amount of play.
- Maximum ball joint vertical play:
- 0 mm (0 in.)
Check the dust cover for damage.
| 4. CHECK AUTOMATIC TRANSMISSION |
Visually check the transmission for fluid leakage. If oil is leaking, find the cause and repair it.
Type
See procedure
A45DE
Click here
A340E
Click here
A343E
Click here
| 5. CHECK MANUAL TRANSMISSION |
Visually check the transmission for fluid leakage. If oil is leaking, find the cause and repair it.
Type
See procedure
R351
Click here
G55
Click here
| 6. CHECK DIFFERENTIAL |
Visually check the differential for fluid leakage. If oil is leaking, find the cause and repair it (Click here).
| 7. TIGHTEN PROPELLER SHAFT BOLTS |
Tighten the bolts for propeller shaft.
Type
See procedure
for Long Wheelbase
Click here
for Super Long Wheelbase
Click here
| 8. INSPECT FRONT AND REAR SUSPENSION |
| 9. INSPECT TIRE AND INFLATION PRESSURE |
