Park / Neutral Position Switch Circuit
Circuit diagnosis · Vehicles built Jan 2015 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
DESCRIPTION
The park/neutral position switch assembly outputs switch signals to the door control relay assembly.WIRING DIAGRAM
(Click here)INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK DOOR CONTROL RELAY ASSEMBLY |
for LH Side
Disconnect the door control relay assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
q4-10 (CPSW) - Body ground
Ignition switch ON, shift lever not in P
Below 1 V
q4-10 (CPSW) - Body ground
Ignition switch ON, shift lever in P
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Door Control Relay Assembly)
for RH Side, w/ Power Slide Door
Disconnect the door control relay assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
I4-10 (CPSW) - Body ground
Ignition switch ON, shift lever not in P
Below 1 V
I4-10 (CPSW) - Body ground
Ignition switch ON, shift lever in P
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Door Control Relay Assembly)
|
|
||||
| OK | ||
| ||
| 2. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Remove the park/neutral position switch assembly.
- for A340E : Click here
- for A343E : Click here
- for AC60E : Click here
- for A340E : Click here
Inspect the park/neutral position switch assembly.
- for A340E : Click here
- for A343E : Click here
- for AC60E : Click here
Result Result
Proceed to
OK
A
NG (for A340E)
B
NG (for A343E)
C
NG (for AC60E)
D
- for A340E : Click here
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
