C2198/98 Initialization Switch (for Test Mode DTC)
Diagnostic trouble codes · Vehicles built Jan 2017 – Nov 2017
Versions by build date: Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C2198/98 |
Test mode procedure is performed. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
- It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
- When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
| 1. INSPECT TIRE PRESSURE WARNING RESET SWITCH |
Turn the ignition switch off.
Remove the tire pressure warning reset switch (Click here).
Inspect the tire pressure warning reset switch (Click here).
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND RECEIVER) |
Disconnect the I35 tire pressure warning reset switch connector.
Disconnect the T38 tire pressure warning ECU and receiver connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
T38-7 (CLSW) - I35-6
Always
Below 1 Ω
T38-7 (CLSW) or I35-6 - Body ground
Always
10 kΩ or higher
I35-3 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
