Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH › 2019.02–2019.06
RM35X0E _58 Vehicle Interior _078381 LIGHTING (INT) _0381274 ROOM LIGHT SWITCH A

LIGHTING (INT)  ROOM LIGHT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during room light switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures not Performed Link
Disconnect cable from negative(-) battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures not Performed Necessary Procedures Link

*: w/ Stop and start system

Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION (for Full-trim, RHD)

CAUTION:
B407254

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Full-trim, RHD)


CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative(-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 55631A 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER TRAY STOPPER

Hide 55011A 4.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55044C 5.REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 55404E 6.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 33622 7.DISCONNECT NO. 1 SHIFT LEVER KNOB COVER (for Automatic Transmission)

Hide 33504F 8.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58840Q 9.REMOVE SHIFTING HOLE COVER ASSEMBLY (for Manual Transmission)

Hide 35970F 10.REMOVE POSITION INDICATOR HOUSING ASSEMBLY (for Automatic Transmission)

Hide 55405B 11.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)

Hide 55900 12.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

Hide 55414A 13.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (for Semi-trim)

Hide 67912A 14.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE LH (for Full-trim)

Hide 67914B 15.REMOVE FRONT DOOR SCUFF PLATE LH (for Full-trim)

Hide 62112 16.REMOVE COWL SIDE TRIM BOARD LH (for Full-trim)

Hide 55318C 17.REMOVE INSTRUMENT SIDE PANEL LH (for Full-trim)

Hide 55641 18.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER (for Full-trim)

Hide 53601 19.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for Full-trim)

Hide 77306 20.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for Full-trim)

Hide 55432D 21.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for Full-trim)

Hide 55433B 22.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for Full-trim)

Hide 55445B 23.REMOVE INSTRUMENT PANEL FINISH PLATE (for Full-trim, LHD)

Hide 55313 24.REMOVE LOWER INSTRUMENT PANEL LH (for Full-trim, LHD)

Hide 73900 25.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Full-trim, RHD)

Hide 67911B 26.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE RH (for Full-trim)

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 67913B 27.REMOVE FRONT DOOR SCUFF PLATE RH (for Full-trim)

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL


Hide 62111C 28.REMOVE COWL SIDE TRIM BOARD RH (for Full-trim)

Hide 55632B 29.REMOVE NO. 2 INSTRUMENT PANEL UNDER TRAY SUPPORT (for Full-trim)

Hide 55012A 30.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for Full-trim)

Hide 55317A 31.REMOVE INSTRUMENT SIDE PANEL RH (for Full-trim)

Hide 55642 32.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER (for Full-trim)

Hide 55312 33.REMOVE LOWER INSTRUMENT PANEL (for Full-trim)

Hide 55438A 34.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL RETAINER (for Full-trim)

Hide 58810J 35.REMOVE CONSOLE BOX ASSEMBLY (for Full-trim, w/ Console Tray)

Hide 58533C 36.REMOVE CENTER FLOOR CARPET COVER RH (for Full-trim)

Hide 58534E 37.REMOVE CENTER FLOOR CARPET COVER LH (for Full-trim)

Hide 55646 38.REMOVE NO. 3 INSTRUMENT PANEL UNDER COVER (for Full-trim)

Hide 55434B 39.REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Full-trim)

Hide 55320 40.REMOVE LOWER NO. 2 INSTRUMENT PANEL ASSEMBLY (for Full-trim)

Hide 55413D 41.REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL (for Full-trim)

Hide 55410C 42.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55670 43.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55447C 44.REMOVE NO. 2 SWITCH HOLE BASE

Hide 84172 45.REMOVE ROOM LIGHT SWITCH

a.
E415112C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and remove the room light switch as shown in the illustration.