86190C
1.INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY
w/o Console Tray:
|
Install in this Direction |
Attach the claw to install the No. 1 stereo jack adapter assembly as shown in the illustration.
w/ Console Tray:
|
Install in this Direction |
Attach the claw to install the No. 1 stereo jack adapter assembly as shown in the illustration.
55524
2.INSTALL SWITCH BASE HOLE COVER (w/ Console Tray)
55646
3.INSTALL NO. 3 INSTRUMENT PANEL UNDER COVER (w/o Console Tray)
58534E
4.INSTALL CENTER FLOOR CARPET COVER LH (w/o Console Tray)
58533C
5.INSTALL CENTER FLOOR CARPET COVER RH (w/o Console Tray)
55438A
6.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL RETAINER (w/o Console Tray)
55642
7.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER (w/o Console Tray)
55318C
8.INSTALL INSTRUMENT SIDE PANEL LH (w/o Console Tray)
55012A
9.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (w/o Console Tray)
55632B
10.INSTALL NO. 2 INSTRUMENT PANEL UNDER TRAY SUPPORT
62112
11.INSTALL COWL SIDE TRIM BOARD LH (w/o Console Tray)
67914B
12.INSTALL FRONT DOOR SCUFF PLATE LH (w/o Console Tray)
67912A
13.INSTALL FRONT DOOR OUTSIDE SCUFF PLATE LH (w/o Console Tray)
73900
14.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/o Console Tray)
55433B
15.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (w/o Console Tray)
55044C
16.INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (w/o Console Tray)
55432D
17.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (w/o Console Tray)
77306
18.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (w/o Console Tray)
53601
19.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (w/o Console Tray)
55641
20.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER (w/o Console Tray)
55317A
21.INSTALL INSTRUMENT SIDE PANEL RH (w/o Console Tray)
55011A
22.INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (w/o Console Tray)
55631A
23.INSTALL NO. 1 INSTRUMENT PANEL UNDER TRAY STOPPER
62111C
24.INSTALL COWL SIDE TRIM BOARD RH (w/o Console Tray)
67913B
25.INSTALL FRONT DOOR SCUFF PLATE RH (w/o Console Tray)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION
67911B
26.INSTALL FRONT DOOR OUTSIDE SCUFF PLATE RH (w/o Console Tray)
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>INSTALLATION
27.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/o Console Tray)
for 7GR-FKS:
for 1GD-FTV:
28. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (w/o Console Tray)
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
29.PERFORM DIAGNOSTIC SYSTEM CHECK (w/o Console Tray)
30.CHECK SRS WARNING LIGHT (w/o Console Tray)