The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the EGR cooler removal/installation are shown below.
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
·
Replacement of diesel throttle body assembly ·
Replacement of electric EGR control valve assembly |
Perform initialization | - |
|
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
1.DRAIN ENGINE COOLANT
85110
2.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
55701J
3.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
26100G
4.REMOVE DIESEL THROTTLE BODY ASSEMBLY
87209
5.REMOVE WATER HOSE SUB-ASSEMBLY (w/ Heater)
16278
6.REMOVE NO. 2 WATER BY-PASS PIPE
89421C
7.REMOVE DIESEL TURBO PRESSURE SENSOR
23265C
8.REMOVE GAS FILTER
12632
9.REMOVE NO. 2 ENGINE COVER BRACKET
23941
10.DISCONNECT NO. 1 FUEL FILTER PROTECTOR
82121
11.DISCONNECT ENGINE WIRE
25804
12.REMOVE VACUUM CONTROL VALVE SET
25625
13.REMOVE EGR VALVE BRACKET
25612
14.REMOVE NO. 2 EGR PIPE
16206B
15.REMOVE NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Detach the clamp and disconnect the No. 4 fuel hose from the No. 3 water by-pass pipe sub-assembly.
Slide the clamp and disconnect the No. 8 water by-pass hose from the No. 3 water by-pass pipe sub-assembly.
Slide the clamp and disconnect the No. 9 water by-pass hose from the electric EGR control valve assembly.
Remove the 2 bolts and No. 3 water by-pass pipe sub-assembly from the No. 1 EGR cooler.
16209
16.DISCONNECT NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY
25601
17.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY (for Single Actuator EGR Bypass Valve)
25601
18.DISCONNECT EGR PIPE SUB-ASSEMBLY NO.1 (for Double Actuator EGR Bypass Valve)
19.REMOVE NO. 1 EGR COOLER AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
| *A | for Single Actuator EGR Bypass Valve |
| *B | for Double Actuator EGR Bypass Valve |
Remove the 4 bolts and No. 1 EGR cooler and No. 2 EGR valve assembly with electric EGR control valve assembly from the intake manifold.
25681
20.REMOVE NO. 1 EGR COOLER
| *A | for Single Actuator EGR Bypass Valve |
| *B | for Double Actuator EGR Bypass Valve |
Remove the 4 bolts and No. 1 EGR cooler from the No. 2 EGR valve assembly with electric EGR control valve assembly.
Remove the gasket.