The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front stabilizer bar removal/installation are shown below.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
48810
2.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the 2 nuts and front stabilizer link assembly LH from the front stabilizer bar and front shock absorber assembly.
Do not damage the boot of the ball joint.
If the ball joint turns together with the nut, use an 8 mm hexagon socket wrench to hold the stud bolt.
48820B
3.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
4.REMOVE ENGINE ASSEMBLY
for 7GR-FKS with Manual Transmission:
Click hereEngine / Hybrid System>7GR-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
5.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
for 7GR-FKS with Automatic Transmission:
48829A
6.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
48824A
7.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as for the LH side.
48811
8.REMOVE FRONT STABILIZER BAR
Remove the front stabilizer bar with 2 front No. 1 stabilizer bar bushings from the front frame assembly.
48815E
9.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING LH
Remove the front No. 1 stabilizer bar bushing LH from the front stabilizer bar.
48815D
10.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING RH
Perform the same procedure as for the LH side.