Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › EXHAUST PIPE › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _079307 1GD-FTV INTAKE / EXHAUST _0385723 EXHAUST PIPE A

1GD-FTV INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
A356209

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 51406A 1.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 2.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 89463C 4.REMOVE NITROGEN OXIDES SENSOR (w/ Urea SCR System)

Hide 89425C 5.REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR (w/ Urea SCR System)

Hide 23203A 6.REMOVE UREA INJECTOR SET (w/ Urea SCR System)

Hide 17410 7.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

w/ Urea SCR System:

i.
A438478

Remove the 2 exhaust pipe supports.


ii.

Remove the 4 bolts, 2 compression springs and front exhaust pipe assembly.


iii.

Remove the 2 gaskets from the exhaust manifold converter sub-assembly and front exhaust pipe assembly.



b.

w/ EGR Cooler:

i.
A438480

Remove the exhaust pipe support.


ii.

Remove the 4 bolts, 2 compression springs and front exhaust pipe assembly.


iii.

Remove the 2 gaskets from the turbine outlet elbow and front exhaust pipe assembly.



c.

w/o EGR Cooler:

i.
A438479

Remove the exhaust pipe support.


ii.

Remove the 4 bolts, 2 compression springs and front exhaust pipe assembly.


iii.

Remove the 2 gaskets from the exhaust manifold converter sub-assembly and front exhaust pipe assembly.



Hide 17420 8.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

w/ Urea SCR System:

Remove the 2 bolts and then disconnect the center exhaust pipe assembly from the 3 exhaust pipe supports.

A438477C01
0.271,0.094 0.583,0.25 0.313,0.156 10 false *A 3.844,0.104 4.156,0.26 0.313,0.156 10 false *B
*A for High Roof *B for Standard Roof



b.

w/o Urea SCR System:

Remove the 2 bolts and then disconnect the center exhaust pipe assembly from the 3 exhaust pipe supports.

A438481C01
0.365,0.125 0.677,0.281 0.313,0.156 10 false *A 3.844,0.156 4.156,0.313 0.313,0.156 10 false *B
*A for High Roof *B for Standard Roof



c.

Remove the gasket.


Hide 17430 9.REMOVE TAILPIPE ASSEMBLY

a.
A437904

Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.