This DTC relates to the thermostat.
This DTC is stored when the engine coolant temperature does not reach 75°C (167°F) despite sufficient engine warm-up time having elapsed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P012800 | Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) | All of the following conditions are met for 5 seconds (2 trip detection logic): (a) Cold start. (b) The engine is warmed up. (c) The engine coolant temperature is less than 75°C (167°F). |
·
Thermostat ·
Engine cooling system ·
Engine coolant temperature sensor ·
ECM |
Class B2 | DTC stored | SAE Code: P0128 |
| DTC No. | Data List |
|---|---|
| P012800 | Coolant Temperature |
The ECM estimates the engine coolant temperature based on the starting temperature, engine loads, and engine speeds. The ECM then compares the estimated temperature with the actual engine coolant temperature. When the estimated engine coolant temperature reaches 75°C (167°F), the ECM checks the actual engine coolant temperature. If the actual engine coolant temperature is less than 75°C (167°F), the ECM interprets this as a malfunction in the thermostat or the engine cooling system and stores the DTC.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P012800 | With the engine stopped for at least 10 hours, start the engine and drive the vehicle at 100 km/h (62.5 mph) for 20 minutes. |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>REGISTRATION) and initialization (Click here Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>INITIALIZATION).
Click here
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P012800 is output | A |
| DTC P012800 and other DTCs are output | B |
If any DTCs other than P012800 are output, troubleshoot those DTCs first.
A
B
Check for defects in the engine cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the thermostat opening temperature.
Click hereEngine / Hybrid System>1GD-FTV (COOLING)>THERMOSTAT>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the engine coolant temperature sensor.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ENGINE COOLANT TEMPERATURE SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG