2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Vehicle Position Mark is not Updated

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc.



NG
REPLACE MAP DISC
OK


2. CHECK NAVIGATION DISPLAY
  1. Check if a touch scroll can be performed on the map display.

    OK:
    Touch scroll can be performed.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

  1. E120089
    Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
GO TO "SPEED SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cursor or Map Rotates when Vehicle Stopped (from Jul 2010)Vehicle Position Mark is not Updated (Aug 2008 – Jun 2010) →