Vehicle Position Mark is not Updated
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
INSPECTION PROCEDURE
| 1. CHECK MAP DISC |
 |
- Check that the map disc is not deformed or cracked.
- OK:
- No deformations or cracks on the map disc.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK NAVIGATION DISPLAY |
 |
Check if a touch scroll can be performed on the map display.
- OK:
- Touch scroll can be performed.
|
NG |
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
| 3. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE) |
 |
- Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).
While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.
- OK:
- The readings are almost equal.
|
NG |
 |
|
| GO TO "SPEED SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|