2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Vehicle Position Mark is not Updated

Circuit diagnosis · Vehicles built Jul 2010 – Jun 2012

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012

INSPECTION PROCEDURE


1. CHECK MAP DISC

  1. I100152E12
    Check that the map disc is not deformed or cracked.

    OK:
    No deformations or cracks on the map disc



NG
REPLACE MAP DISC
OK


2. CHECK NAVIGATION DISPLAY
  1. Check if touch scrolling can be performed on the map display.

    OK:
    Touch scrolling can be performed.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK VEHICLE SENSOR (OPERATION CHECK)

  1. E176549
    Enter the "Vehicle Sensors" screen (Check GPS&Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
CHECK DTC OUTPUT (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Position Mark is not Updated (Aug 2008 – Jun 2010)Vehicle Position Mark is not Updated (from Jul 2012) →