Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for HDD)
HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jul 2010 – Jun 2012
Versions by build date: Jul 2010 – Jun 2012 from Jul 2012
HINT:
Use the following procedure to troubleshoot the navigation system.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Measure the battery voltage with the ignition switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
NEXT
3.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
Ask the customer about symptoms and confirm malfunctions.
Result:
Result
Proceed to
Other symptoms occurred.
A
The screen displays nothing.
B
B.
A
Refer to Check System Normal Condition (Click here ).
Result:
Result
Proceed to
Symptom is not normal operation.
A
Symptom is normal operation.
B
B.
A
Refer to DTC Check/Clear (Click here ).
Result:
Result
Proceed to
DTC is output.
A
DTC is not output.
B
HINT:
If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part (Click here ).
B.
A
Refer to DTC Check/Clear (Click here ).
HINT:
The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.
NEXT
Refer to DTC Check/Clear (Click here ).
Result:
Result
Proceed to
DTC is output.
A
DTC is not output.
B
HINT:
Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.
Refer to the detailed description on the diagnostic screen as necessary (Click here ).
Check the DTCs and inspect the area that the code indicates.
B.
A
8.DIAGNOSTIC TROUBLE CODE CHART
Find the output code in Diagnostic Trouble Code Chart (Click here ).
NEXT.
Refer to Problem Symptoms Table (Click here ).
Result:
Result
Proceed to
Fault is not listed in Problem Symptoms Table.
A
Fault is listed in Problem Symptoms Table.
B
HINT:
If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms (Click here ).
B.
A
10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
Refer to Terminals of ECU (Click here ).
NEXT
Adjust, repair or replace as necessary.
NEXT
12.RECHECK FOR DIAGNOSTIC TROUBLE CODE
HINT:
After clearing the DTCs, recheck for DTCs.
NEXT
13.PERFORM CONFIRMATION TEST
NEXT