2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jul 2012

Versions by build date: Jul 2010 – Jun 2012 from Jul 2012

HINT:
  1. Use the following procedure to troubleshoot the navigation system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the ignition switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    3.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
    1. Ask the customer about symptoms and confirm malfunctions.

      Result:
      Result
      Proceed to
      Other symptoms occurred.
      A
      The screen displays nothing.
      B


    B.
    A

    4.OPERATION CHECK
    1. Refer to Check System Normal Condition (Click here).

      Result:
      Result
      Proceed to
      Symptom is not normal operation.
      A
      Symptom is normal operation.
      B


    B.
    A

    5.CHECK FOR DTC
    1. Refer to DTC Check/Clear (Click here).

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B

      HINT:
      If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part (Click here).


    B.
    A

    6.DTC CLEAR
    1. Refer to DTC Check/Clear (Click here).

      HINT:
      The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.

    NEXT

    7.RECHECK FOR DTC
    1. Refer to DTC Check/Clear (Click here).

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B

      HINT:
      1. Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.
      2. Refer to the detailed description on the diagnostic screen as necessary (Click here).
      3. Check the DTCs and inspect the area that the code indicates.


    B.
    A

    8.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in Diagnostic Trouble Code Chart (Click here).


    NEXT.
    9.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table.
      A
      Fault is listed in Problem Symptoms Table.
      B

      HINT:
      If the symptom does not recur and no DTC is output, attempt to reproduce the symptoms (Click here).


    B.
    A

    10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).

    NEXT

    11.CHECK CIRCUIT
    1. Adjust, repair or replace as necessary.

    NEXT

    12.RECHECK FOR DIAGNOSTIC TROUBLE CODE

      HINT:
      After clearing the DTCs, recheck for DTCs.

    NEXT

    13.PERFORM CONFIRMATION TEST
      NEXT

      ← HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2010 – Jun 2012)OPERATION CHECK (Jul 2010 – Jun 2012) →