Engine Coolant Temperature Receiver Gauge Malfunction
Circuit diagnosis · Vehicles built from Jul 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication lines (CAN No. 1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Perform troubleshooting with the "SFI System" (Click here for 2GR-FE).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
- Result:
Result
Proceed to
CAN communication DTC is not output.
A
CAN communication DTC is output.
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Ignition switch on (IG).
Turn the tester on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the operation by referring to the table below.
Combination Meter: Tester Display
Test Part
Control Range
Diagnostic Note
Water Temperature Meter Operation
Engine coolant temperature receiver gauge
Low, Normal, Hi
-
- OK:
- Needle indication is normal.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Ignition switch on (IG).
Turn the tester on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Check the values by referring to the table below.
Combination Meter: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Coolant Temperature
Engine coolant temperature/Min.: 0°C (32°F), Max.: 127.5°C (261.5°F)
After warming up: 80 to 95°C (176 to 203°F)
- If -40°C (-40°F): Sensor circuit open
- If 140°C (284°F) or more: Sensor circuit shorted
- OK:
- Engine coolant temperature value displayed on the tester is almost the same as needle indication.
- If -40°C (-40°F): Sensor circuit open
|
|
||||
| OK | |
| 4. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Ignition switch on (IG).
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Check the values by referring to the table below.
Engine and ECT: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Coolant Temp
Engine coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F)
After warming up: 80 to 100°C (176 to 212°F)
-
- OK:
- Engine coolant temperature value displayed on the tester is almost the same as the actual engine coolant temperature.
|
|
||||
| OK | |
| 5. REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or a normal one (Click here).
- OK:
- The operation of the combination meter assembly returns to normal.
|
|
||||
| OK | ||
| ||
