TRC OFF Indicator Light Remains ON
Circuit diagnosis · Vehicles built from Jul 2012
Versions by build date: Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If TRC control is turned off, the TRC OFF indicator light will come on.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | |
| 2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
- OK:
- The connector is securely connected.
|
|
||||
| OK | |
| 3. CHECK BATTERY |
Check the battery voltage.
- Standard voltage:
- 11 to 14 V
|
|
||||
| OK | |
| 4. READ VALUE ON INTELLIGENT TESTER (VSC OFF SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on the intelligent tester (Click here).
ABS / VSC / TRC: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
TRC/VSC Off Mode
VSC OFF switch / Normal, TRC OFF, Unknown or VSC OFF
Normal: Normal
TRC OFF: TRC off mode
Unknown: Unspecified
VSC OFF: VSC off mode
-
Using the intelligent tester, check the switch condition on the intelligent tester changes according to VSC OFF switch operation.
- OK:
- The intelligent tester display changes according to VSC OFF switch operation.
|
|
||||
| OK | |
| 5. INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Perform the Active Test of the combination meter (meter CPU) using the intelligent tester (Click here).
Check the combination meter.
- OK:
- The TRC OFF indicator light turns on or off in accordance with the intelligent tester operation.
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).
|
|
||||
| OK | ||
| ||
| 6. INSPECT VSC OFF SWITCH |
Turn the ignition switch off.

Disconnect the VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
9 (+) - 6 (E)
Switch is pushed in
Below 1 Ω
9 (+) - 6 (E)
Switch is not pushed in
10 kΩ or higher
|
|
||||
| OK | |
| 7. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Disconnect the skid control ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A24-30 (CSW) - D58-9 (+)
Always
Below 1 Ω
A24-30 (CSW) - Body ground
Always
10 kΩ or higher
D58-6 (E) - Body ground
Always
Below 1 Ω
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| OK | ||
| ||
